As a common indoor lighting device, wall lamps not only have a decorative effect, but also provide good lighting effects. Here are the detailed steps to install the wall light:
1. Turn off the main power switch to ensure safety
Always turn off the main power switch before starting the installation to prevent electric shock and damage to the device.
2. Measure the size of the wall and wall light and determine the installation location
In order to ensure that the wall light matches the size of the wall and can be installed smoothly, the dimensions of the wall and the wall light need to be measured. When determining where to install, take into account the height of the wall lights, their location, and the overall layout of the room.
3. Mark the location of the mounting holes on the wall
Mark the location of the mounting holes on the wall according to the location and height of the wall lamp. Use a tape measure or laser rangefinder to measure and ensure accuracy.
4. Use an electric drill to drill holes in marked locations
Use an electric drill to drill holes in marked locations, and the diameter of the holes should match the diameter of the screws of the wall light. Pay attention to choosing the right drill bit to avoid damaging the wall.
5. Clean up debris from holes in the wall
After drilling, use a cleaning tool to clean up the debris in the wall hole to ensure that the wall light can be installed smoothly.
6. Thread the wire through the conduit of the wall light
Thread the wire through the conduit of the wall lamp and make sure that the wire is properly connected with the power cord of the wall lamp. Be careful not to confuse the neutral and live wires to avoid danger.
7. Fix the wall lamp in the hole in the wall
Fix the wall light in the hole in the wall and use screws to fasten it. When tightening the screws, pay attention to the right amount of force to ensure that the wall lamp can be firmly fixed to the wall.
8. Connect the wires to the wall lights
Connect the wire with the wall light, making sure the wire plug is properly connected with the power cord of the wall light. Pay attention to check whether the connection is firm to prevent loosening or falling off.
9. Turn on the main power switch and test the wall light
Finally, turn on the main power switch and test if the wall light is working properly. If everything is in order, then your wall light has been successfully installed.
