LED downlight features
1.Energy saving: the power consumption of the same brightness is 1/2 of the ordinary energy-saving lamp.
2.Environmental protection: does not contain mercury and other harmful substances, no pollution to the environment.
3.Economy: Because of power saving can reduce electricity expenses, a year and a half can recover the cost of lamps. A family can save tens of yuan in electricity bills a month.
4.Low carbon: Saving electricity is equivalent to reducing carbon emissions.
5.Longevity: The life of LED lamps is 100,000 hours, according to the use of six hours a day, an LED lamp can be used for 40 years.
How to maintain LED downlights
1. After buying the lamp, do not rush to install, to see the mark of the lamp and read the installation and use instructions, and then install and use the lamp according to the instructions, otherwise there may be danger.
2. In the cleaning and maintenance should be careful not to change the structure of the lamp, do not replace the parts of the lamp, after the end of cleaning and maintenance, the lamp should be installed as is, do not miss the installation, the wrong installation of the lamp parts.
3. The lamp tube in the room should be wiped often with a dry cloth, and pay attention to prevent moisture intrusion, so as to avoid corrosion damage or leakage short circuit phenomenon for a long time; The lamp installed in the toilet and bathroom must be equipped with a moisture-proof lamp shade, otherwise it will greatly shorten the service life; The lamp installed in the kitchen should pay special attention to anti-fume, because the accumulation of oil dirt will affect the lighting of the lamp; Light-colored lampshade transmittance is better, but easy to stick to ash, to be diligent in wiping, so as not to affect the penetration of light; If the lamp is non-metal, it can be wiped with a wet cloth to avoid dust accumulation and hinder the lighting effect.
4. To minimize the number of switches. The principle of the lamp switch is mainly to accelerate sublimation by using a sharp rise in filament temperature. Frequent switching will cause the filament to heat up many times, and more times will naturally shorten the service life of the filament, so do not switch the lamp too frequently.
5. In case of problems, timely replacement of the light source parameters provided by the sign to replace the aging light source in time, when replacing the light source, we must pay attention to the type of light source, interface type, power, color temperature and other key items on the lamp identification, especially can not mistakenly install the type of light source, otherwise it is easy to cause explosions and other safety accidents (such as low-voltage light source access to high-voltage lamps) or direct damage to the light source and electrical appliances. At the same time, when replacing the light source, please note that the lamp should be powered off first, and then replace the light source with the same model and the same power after the light source cools down. Generally, the manufacturer of the lamp will have an obvious maximum limit mark for the light source in the instructions of the lamp. Please note that the light source is less than or equal to the maximum limit.
6.Regularly clean the dust on the lamp surface. Statistics show that if the lamp accumulates too much dust, the average lighting degree of a year will be reduced by about 30%, so cleaning the dust can not only increase the service life of the lamp, but also make the lighting degree higher.
